Single Strand Canyon Cordelettes
3/2 wrap Prusik, 7mm Nylon Cord (New England) Rated: 2300 lbs
3/2 wrap Prusik, 7.5mm Hybrid PER (BlueWater) Rated: 3372 lbf
3/2 wrap Prusik, 8mm Technora PER (BlueWater) Rated: 4046 lbf

Standard Purcell Prusiks
3/2 wrap Prusik, 6mm nylon (New England) Rated: 1650 lbs X 2 = 3300
2/2 wrap Prusik, 6mm nylon (BlueWater) Rated: 1888 lbs X 2 = 3776

Premature Slippage
The 2/2 wrap BlueWater nylon Purcell Prusik slipped at approx. 140 lbs. Likely due to the 2/2 wrap Prusik. This Purcell was not included in any subsequent tests.

Releasable Under Load
We used a 4:1 MA to load each rig to 200 lbs, then 300-340 lbs. All of the hitches could be released under load. The 8mm Technora PER required the most effort to release. Likely because the Technora surface is not as sooth as the other materials. The ability to release under load is a useful attribute for things like transferring load when passing knots in haul systems, rescuer repositioning during tandem rappels and pick-offs, etc.

Maximum Load Before Unintentional Slipping
Surprisingly, all of the hitches slipped at approximately the same load, 660 to 680 lbs, except the Technora PER, which did not slip until 770 lbs. This slipping is not considered a bad thing as it acts as a kind of pressure relief valve. Better to have the hitch slip under load to absorb energy than to have the cord break.

The hitches all slipped approximately 2-3 inches, then stopped slipping on their own because the slippage caused some of the tension to come off the system and reduce the load. The slippage also created enough heat to fuse some of the hitches to the cord. The nylon fused and could not be moved without completely untying the hitches. The polyester portion of the Hybrid PER fused, but could be moved upon partially untying the hitch. The Technora portion of the Hybrid PER did not fuse due to its high heat resistance. The Technora PER did not fuse at all, but the hitch had cinched down tight enough to require partial untying to move it.

If slippage occurred under a continuous static load, the hitches might continue to slip until fusing stopped the slipping or until the loop closed completely.

If slippage occurred under a dynamic load, the hitches would be expected to perform like a normal Purcell Prusik – the slippage would absorb some of the energy. As the load is reduced, the hitch will stop slipping.

And … it was fun.

I anticipate the following uses:

• Tandem rappels
• Pick-off rescues
• Passing a knot when hauling
• Equalizing an anchor
• Pre-tensioned front tie or back tie
• Adjustable length PCD (tie cord onto rope with a hitch?)
• Adjustable foot loop for ascending
• Adjustable safety line (anchor to edge)
• Load releasing hitch

I will post instructions and photos as I further develop each of these techniques.

The Totem is a very versatile rappelling device. This Tech Guide describes a few of the most common methods – standard figure eight, vertaco and throttle modes – plus how to add friction on the fly and how to lock off mid-rappel